Filter
Top Products
2-3
Cisco BTS 10200 Softswitch SIP Protocol User Guide
OL-5352-03
Chapter 2 SIP Protocol Subscriber Features
The Cisco BTS 10200 generates a warning event when a request from a client fails authentication.This
can be indicative of a provisioning error, or of an attempt by an unauthorized client to communicate with
the Cisco BTS 10200.
The contacts registered for an AOR may be looked up using the status CLI command, as demonstrated
by the following example.
CLI>status sip-reg-contact AOR_ID=4692551884@sia-SYS44CA146.ipclab.cisco.com
AOR ID -> 4692551884@sia-SYS44CA146.ipclab.cisco.com
USER -> 4692551884
HOST -> 10.88.11.237
PORT -> 5060
USER TYPE -> USER_PHONE_TYPE
EXPIRES -> 3600
EXPIRETIME -> Thu Jan 22 14:33:36 2004
STATUS -> REGISTERED CONTACT
Reply :Success:
Static Registration
The Cisco BTS 10200 also supports static registration for endpoints that do not support dynamic
registration through the SIP REGISTER message. However, dynamic registration takes precedence over
static registration.
Note Static registration is not recommended, as it does not allow terminal mobility.
For provisioning information, refer to the Static Contact table section of SIP Adaptor Configuration
Parameters, page 5-30.