Filter
Top Products
English
8 TTX754
280-8285-00
8. WIRING CONNECTIONS
Connect the unit as follows.
Notes:
*1 Connect the cable to the terminal of equipment (center unit) that is connected by connection
cables (CeNET cable) with the L-shaped terminals.
*2 Connection requires a CCA-389 conversion cord (RCA3P → mini DIN8P) which is sold
separately.
*3 If you are connecting an antenna other than a 4 system diversity antenna, connect it to the MAIN
terminal on the far right.
*4 Connect the terminal to the lead wire on the lamp side of the parking brake lamp switch. After
connection, apply the parking brake, then check that the TV displays an image.
• If the PKB cable is not connected to the side brake, some units may not operate.
Main unit (
such as the Clarion VRX756VD
)
This unit (TTX754)
For connection of the Clarion CD changer (sold separately) for CeNET use.
For connection of the rear seat monitor (sold separately).
For connection of the monitor (such as the Clarion VRX756VD, sold separately).
Supplied RCA video cable (∗ 1)
For connection of a video appliance (∗ 2) such as a handy camera (sold separately).
For connection of a Clarion CCD camera (sold separately).
Antenna main (MAIN) terminal
Terminal (∗ 4) for connection
to parking brake.
Supplied PKB cable
To parking brake
NAVI/CCD terminal.
Supplied CeNET cable (∗ 1)
For connection (∗ 3) of a Clarion
antenna such as ZCP-104 (sold
separately).
*
For connection of VRX756VD, connect the CCD camera to the
NAVI/CCD terminal of VRX756VD.