Filter
Top Products
GB
6
SET UP BY USING THE LIBRARY SEARCH FACILITY
If you cannot identify the correct code for your TV from the code list use
the code search facility.
1) Switch on the TV you wish to control.
2) Press and hold down the STANDBY key on the smart 1F and at the
same time press and hold down the OK key. Keep both keys
pressed down for approximately 5 seconds until the indicator
light on the STANDBY key being held down lights and remains on.
Release both keys.
3) Point the smart 1F towards the TV you wish to control and press
either the P up or P down key repeatedly until your TV switches off.
The P up key searches forwards through the library and the P down
key searches backwards through the library. Alternatively hold down
the P up or P down key and the smart 1F will search through each
available code at approximately one-second intervals.
4) When your TV switches off stop pressing the key. Should you
accidentally press the key after your TV has switched off you can
back up by pressing the opposite key.
5) Press and release the STANDBY key and the indicator will blink 3 times.
This indicates that you have now stored the code into the handset.
6) Switch your TV back on and try all of the functions of the remote control.
7) If your TV does not respond correctly to the commands from the
remote control continue the search process until you nd a suitable
code by repeating steps 1) to 5). The handset will continue its search
from the last code you selected.
Please be patient when searching by this method as the library contains a large
number of codes and it may take some time to nd a suitable code.
READ OUT THE STORED CODE NUMBER
Having found a suitable code by the search method it is useful to
identify the code number and record this in the battery compartment
for future use.
1) Press and hold down the STANDBY key on the smart 1F and at the
same time press and hold down the OK key. Keep both keys
pressed down for approximately 5 seconds until the indicator
light on the STANDBY key being held down lights and remains on.
Release both keys.
2) Press and release the MUTE key.
3) The indicator light will then blink the number of the rst digit, pause,
blink the number of the second digit, pause and then blink the number of the
third digit. (e.g. 1 blink = digit 1, 6 blinks = digit 6. Note 10 blinks = digit 0).
4) The handset will then automatically return to normal operation.
Make a note of the code number found above, on the label inside the
battery compartment for future use.
smart1F.indd 6 01.10.2008 10:20:29 Uhr