Filter
Top Products
9032 Owner’s Manual •
••
• (V 2.0) Page 11 of 24
Board Installation
Use the following steps to install the card in the openGear
TM
8310 frame:
1. Refer to the Owner’s Manual of the openGear
TM
8310 frame to ensure that the frame
is properly installed according to instructions.
Warning
Heat and power distribution requirements within a frame may dictate
specific slot placement of cards. Cards with many heat-producing
components should be arranged to avoid areas of excess heat build-up,
particularly in frames using convection cooling.
2. After selecting the desired frame installation slot, hold the card by the edges and
carefully align the card edges with the slots in the frame. Then, fully insert the card
into the frame until the rear connection plugs are properly seated on the midplane and
rear modules.
This completes the procedure for installing the card in the openGear
TM
8310 frame.
Software Version
This manual is written for software release number 2.0.
To view the current software release number of your 9032 check the information submenu on the front
edge controls or the card info menu in DashBoard.
To upgrade your 9032 software, go to the download page at www.cobaltdigital.com to download the
latest release, and upload the file through DashBoard (see DashBoard user manual, 3-5).