COBY electronic TF-DVD1256 DVD Player User Manual


 
14
Remote Control
To use the remote, point it at the remote sensor of the player. Operate the remote within 15
feet of the sensor and at an angle of +/- 60 degrees.
Replace the battery if the remote control does not work.
Remove the battery from the remote if it will not be used for a long period of time.
GETTING STARTED
AC Adapter
To wall outlet
Power Supply
Using the AC/DC Adapter
This AC/DC adapter should be used with 100-240V
50/60Hz AC wall outlets.
DC Out: 13.5V, 3.5A max.
Caution:
Do not connect the power plug to a power outlet
other than that which is indicated here and on
the label as this may result in the risk of re or
electric shock.
Do not handle the power plug with wet hands.
Doing so may cause electric shock.
Only use AC adapters of the type specied here.
Failure to do so may case a re or damage the
player.
Battery Operation (DC)
This unit can be powered by 10 x “D” batteries. To install the batteries:
To remove the battery compartment cover, press
the two locking tabs in the direction of the arrow to
release them, and then lift the cover off.
Insert 10 “D” batteries, taking care to match the
polarities (+ / -) with the markings in the battery
compartment.
Replace the cover.
(The unit can function on AC power with the batteries
installed.)
WARNING
The batteries used in this device may present a re or chemical burn if mistreated. Do not
recharge, disassemble, incinerate, or heat the battery (~212
F). Keep batteries away from
children.
Power Management
If the player will not be in use for a long period of time, set the Power Switch to the OFF position,
remove the battery, and unplug the player.
1.
2.
3.
10 x "D"
Batteries