Filter
Top Products
Synergy.doc
- 13 -
function. In the remote's TV mode, this button changes the Input Source (Input 1, Input 2...) on your TV. In the
remote's VCR mode, this button changes the TV / VCR Input on your VCR.
You can program this button so that in the remote's Cable mode, [INPUT] will operate the Input function
on your TV or VCR, eliminating the need to change modes on the remote.
To program [INPUT] to operate your TV Input function in the remotes cable mode...
1. Press [INPUT], then [OK] together
until the [CBL] button illuminates.
2. Press [TV]. The [CBL] button will blink 3-times and go out.
Note: You can also press [VCR] in step 2 above to operate the TV / VCR function on your VCR. Or press [CBL] to
return to the normal CBL Video Source function.
13. Reset
To reset your remote control to its factory default settings…
1. Press [CBL], then [OK] together
until the [CBL] button illuminates.
2. Press [MENU], then [MENU] again. The [CBL] button will blink 3 times and go out.
Reset returns the ALL SmartKey
®
, Volume / Mute, Mode Lock™ features to their factory default settings.
14. Additional Programming Information, Troubleshooting, Terms
Additional Programming Information
1. The power / mode buttons will illuminate in slow-rotation (i.e. CBL Æ TV Æ VCR Æ DVD Æ AUDIO Æ CBL…)
while the remote is in a programming mode. In the absence of a keypress entry, the power / mode buttons will
stop illuminating after 45 seconds and the remote will exit the programming mode.
2. When programming the remote control using the [CH +] or [CH -] buttons (Power function) in the Point and
Press® Programming method, you may find a code that turns a device off but not back on. If this happens…
a. The correct code has not been found as you may have a code that operates some but not all of the
functions of your device. Continue pressing [CH +] until your device turn on.
OR
b. You may have gone past the correct matching code. Try pressing [CH -] one press at a time until you
find a code that turns your device back on.
3. When using the Point and Press® Programming method, you can also program your remote using buttons other
than the [CH +] or [CH -] as described in Section 5 as follows:
a. [VOL +] – to “go forward” through the codes using the “VOL +” function on your devices.
b. [VOL -] – to “go back” through the codes using the “VOL -“ function on your devices.
Note: When you find the correct code, the volume of the device being programmed will increase or
decrease.
c. [S] - to “go forward” through the codes using the “CH +” function on your devices.
d. [T] - to “go back” through the codes using the “CH –“ function on your devices.
Note: When you find the correct code, the channel of the device being programmed will increase or
decrease.
e. [XX] - to “go forward” through the codes using the “Fast Forward” function on your devices.
f. [WW] - to “go back” through the codes using the “Rewind” function on your devices.