Filter
Top Products
© 1994, The Chamberlain Group, Inc.
114A1527F All Rights Reserved Printed in Mexico
SET RECEIVER TO MATCH REMOTE CONTROL(S) CODE
Pry open the front panel of receiver case with a coin or a
screwdriver.
1. Press and
hold
the remote control push button.
2. Then press and release the "Smart" button on the
receiver. The adjacent indicator light will
flash
once.
Release the remote control push button.
The opener will now operate when the push button on
either the receiver or the remote control transmitter is
pressed.
Repeat Steps 1 and 2 for each remote control that
will be used to operate the garage door opener.
NOTE: If the remote control push button is not held
down until the receiver indicator light flashes, the
receiver will not learn the code.
TO ERASE ALL REMOTE CONTROL CODES
• Press and hold the "Smart" code button on the
receiver panel until the indicator light turns off (about
6 seconds).
All
the codes the receiver has learned
will be erased.
• Repeat Steps 1 and 2 to reprogram the receiver for
each remote control transmitter in use.
MOUNTING RECEIVER ON GARAGE WALL
Fully extend the antenna wire below bottom of case.
Fasten the receiver to an inside garage wall with dry wall
screws provided. A convenient place is alongside the
service door and
OUT OF THE REACH OF CHILDREN.
Attach one end of 3-strand bell wire (not supplied) to
receiver terminals 1, 2 and 3. Connect the other end to
the three opener terminals used for push button controls
and radio power. Use insulated staples to secure bell
wire between receiver and opener.
Reconnect power to the opener. The receiver push bar
should light. If it does not, use Transformer Model 85.
NOTE: With the transformer, use a 2-wire
connection
only.
Attach wire to receiver terminals 1
and 2 and to the opener terminals used for push
button control. Plug the transformer into receiver
and 120 Volt outlet as shown.
To Wall Outlet
Model 85
Transformer
OPENER
WALL
PUSH
BUTTON
TRANS
PRIMARY
24v
1
2
3
Universal Radio
Control (Top)
Common
Push Button
Radio Pwr.
#3 Connection
(optional)
3
2
1
UNIVERSAL RECEIVER
©
The receiver can be set for either constant or momentary
closure on the output contacts. With the jumper in the
“MOM” (Momentary) position, the contacts will close for
1/4 second regardless of the length of radio
transmission. With the jumper in “CONST” (Constant)
position, the contacts will stay closed as long as the
radio continues transmitting.
The receiver is factory set at M.
TO SET OUTPUT DURATION
The use of radios incorporating constant closure
contacts on residential operators with fail-safe
infra-red protectors is prohibited.
WARNING
Remote Control Transmitter
Push Button
Smart
Button
Option Jumper
Indicator Light
UNIVERSAL RECEIVER
MOM.
CONST.
Output
Duration
Terminals
Jumper
MOMENTARY
OPERATION
MOM.
CONST.
Output
Duration
Terminals
Jumper
CONSTANT
OPERATION