Filter
Top Products
Television RF system NTSC M+ATSC
Video Color System PAL/NTSC
Channel and frequencies CH135
Power input AC 110240V, 50/60 Hz
Power consumption see the ration label
Audio output 6W +6W (Rated output)
AIR CH2CH69 CABLE CH1
If the display fails or the performance dramatically, check the display in accordance with the following
instructions. Remember to check the peripherals to pinpoint the source of the failure. If the display still
fails to perform as expected, connect the dealer for assistance.
No Power
No Sound
No Response Of the remote
control
The Screen Flash In VGA
Mode
Symptom
Check the power connection.Pull the plug out, wait for 60 seconds,
then reconnect the power and turn on the set.
Increase the volume. Check that if the set is on the mute state or not.
Check the voice setting condition. Check the voice mode setting condition.
Check the effect of the batteries. If needed, please replace the batteries or
clean the remote control sensor window. The distance between the set and
the remote control should be less than 6 meters.
The parameter is too big.Please use saftey mode when restart the PC,
and set the parameter of the monitor according to the instruction.
DEALING METHOD
Please modify parameter of the monitor according to the instruction.
Check the antenna connection.
Please pull the plug out when clean the LCD screen. Using soft, clean cloth
to wipe it off. If need to clean further, please use dr cloth, don't use naphtha
or other thinner liquid.
Clean The TV Set
Some Interfere In The VGA
Mode
Abnormal Color
Specifications
Simple Troubleshooting
19