Filter
Top Products
I
nstruction ManualManual
I
NSTALLATION
- Please read the safety instructions in this manual completely before installation.
- Install your unit in an area where direct sunlight will not fall upon the screen.
- Soft, indirect light is best for television viewing.
- Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper ventilation.
- Optimum television viewing distance is 3-5 times the screen's size.
A
uto-Degaussing
C
olor TV is easily affected by magnetism which leads to color distortion. If your unit is moved or affected by
n
ear magnetic components or appliances with power on, please power off your unit for at least 1 hour. The
b
uilt-in auto-degaussing circuit will eliminate the magnetism interference.
A
uto off when no signal received
T
he TV set will automatically enter into Standby mode when the following conditions are met.
1
.TV is in antenna mode.
2
.Current channel has no signal.
3
.No key is pressed within 15 minutes.
N
otes:
1) It is recommended that a 75 ohm coaxial cable be used in order to eliminate interference and noise which
may occur due to nearby radio transmissions.
2) The antenna cable should not be tied together with other wiring.
3) Set up a lightning rod and check it regularly when an outdoor antennais used.
1
. Remove the battery compartment lid. Insert two AAA batteries (included) into the battery compentment in the rear
of the remote control.
2
. Make sure the positive (+) and negative (-) polarities are correctly aligned.
3
. Reattach the battery lid.
N
otes:
1) Alkaline batteries are recommended for longer life.
2) Always replace both batteries at the same time.
3) Do not expose batteries to fire or break them open.
4) To avoid battery leakage, remove batteries from the remote control when it is not being used for a long period
of time.
I
nstalling the Remote Control Batteries
75-ohm coaxial cable (not supplied)
300-ohm twin-lead cable (not supplied)
OR
Antenna adapter
(not supplied)
VHF
UHF
or Cable
VHF
UHF
C
onnecting the Antenna
RF Input
(back of TV unit)
OR
U/V mixer
(not supplied)
8