Filter
Top Products
-11-
ALIGNMENT INSTRUCTION
4) WHITE BALANCE ADJUSTMENT(S8)
- Receive a good local channel.
- Enter the service mode and select service adjustment S8.
- You can see the OSD as shown in below.
R-GAIN 32 SRC R-BIAS 32
G-GAIN 32 SRC G-BIAS 32
B-GAIN 40 CVI R-BIAS -8
R-BIAS 32 CVI G-BIAS 10
G-BIAS 32
- Using volume up or volume down, adjust service adjustment data of R-GAIN/G-GAIN/B-GAIN and
R-BIAS/G-BIAS until a good gray scale with normal whites is obtained.ALIGNMENT INSTRUCTIONS
5) DIGITAL PRESET(D.P) ADJUSTMENTS(S9)
SUBBRIGHTNESS ADJUSTMENT
- Receive a good local channel.
- Enter the service mode and select service adjustment S9.
- You can see the OSD as shown in below.
DP-Brightness 10
DP-Contrast 10
DP-Color 5
DP-Sharpness 18
- Select DP-Brightness item, adjust DP-Brightness data value to obtain normal
brightness level.
DP-Contrast
- Fixed value = 10
DP-Color
- Fixed value = 5
DP-Sharpness
- Fixed value = 18
6) FACTORY OUTGOING MODE (S12 : FACT)
- If you select the S12, then the set becomes factory outgoing status.
- You can see the OSD ¡ SHIPPING OFF¡–
VWSELECT C BADJUST L EXIT
VWSELECT C BADJUST L EXIT