20
Alignment Instructions
1. SERVICE MODE ADJUSTMENTS
Follow the steps below whenever service adjustment is required. See Table-A and Table-B to determine if service
adjustments are required.
1) How to enter the service mode using the user remote control.
• Turn the set on.
• Direct the remote control to the reception window of TV.
• Push buttons of remote control in sequence as follows.
1
--->
MUTE
--->
DISPLAY
--->
MUTE
• Then, the screen will appear as follows.
• Using the channel up or channel down button, select the item you wish to adjust.
(The color of selected item turns into the red.)
• Press the volume up or down button to enter in the service mode you wish to adjust.
2) How to memorize the adjusted values in the service mode.
• Must press DISPLAY button the state which the screen is displaying each of service menus
after all adjustments are completed each of all service menu.
Table-A : Adjust the values of service mode when a part is replaced.
PART ADJUSTMENT
REPLACED NECESSARY UNNECESSARY
I701
(U-COM)
I101
(MAIN)
Initial setting values are written from I701.
Adjusting ltems
S5 RFAGCD
S6 H.PHASE.V.POSI/V.SIZE
S8 RD/BD/RB/GB/BB
S9 Subbrightness
CRT Adjust items related to picture tube only. ( White Balance adjustment )
N O T E S
Data is stored in I703.
O
O
O
O
I703
(EEPROM)