Filter
Top Products
PLAYBACK
39
Time shifting & Saving
Time shifting & Saving
When the HDD/DVD Recorder is turned on or you
press the [HDD] button on the remote control or the
[DVD/HDD] button on the front panel to move to
HDD mode from other menus, the last viewed TV
channel will be tuned in and Time shifting starts
automatically. Time shifting allows ‘pausing’ the
live TV broadcast for up to 60 minutes. At any time,
the viewing can resume. Press [PLAY/PAUSE] to
pause the broadcast, press [PLAY/PAUSE] again to
resume TV viewing. If the system is paused for 60
minutes, it will automatically resume TV viewing.
Time shifting in HDD mode
Navigation in Time Shifting mode
You can navigate in Time shifting mode and control
the output by using the following remote control
keys:
If you are using the default value of “Setup –>
Preferences –> Hard Disk –> Buffer mode –>
Refresh”, and change Channels, the Time shifting
buffer data will be lost. No message will be
provided prior to doing so. However, if you set
“Setup –> Preferences –> Hard Disk –> Buffer
mode –> Preserve”, and change Channels, the Time
shifting buffer data will be maintained.
Time shifting is stored in a buffer that contains 60
minutes of recording. After 60 minutes, the buffer
will be progressively overwritten. If you need to
keep the video contained in this buffer for future
usage, you can Save all or part of the buffer.
During Time shifting, a Timer recording may come
up. As you cannot watch one program in Time
shifting and record another channel, the HDD/DVD
Recorder will prompt you to confirm if you want to
keep the current channel or proceed with Timer
recording. If there is no response, this combination
assumes Timer recording should be started. The
message will appear 5 seconds before the TImer
recording is due.
12 : 34 13 : 34
√ LIVE
Press [STOP] to return to the live broadcast.
Changes the channel
Fast Forward. Press to cycle
through 2, 4, 8, 16, 32X speeds.
Fast Rewind. Press to cycle
through 4, 8, 16, 32X speeds.
Slow forward/reverse. Press to
cycle through 1/2, 1/4 or 1/8
speeds.
Jumps back to the 'jump to
interval' time is set in the setup
menu.
Jumps forward to the 'jump to
interval' time is set in the setup
menu. Refer to page 30.
DG-M12D1P-SA(GB) 2005.11.1 11:27 AM ˘ ` 39 mac001 1200DPI 100LPI