Filter
Top Products
16
Component Video Connection
• If your television is a high-definition or ‘digital
ready’ television, you may take advantage of the
DVD Recorder + VCR’s Progressive Scan output
for the highest video resolution possible.
• If your TV does not accept the Progressive Scan
format, the picture will appear scrambled.
1 Connect the COMPONENT VIDEO OUT jacks on
the DVD Recorder + VCR to the corresponding in
jacks on your TV using a Y Pb Pr cable (C) if the
component (Y, Pb, Pr) is available on your TV.
2 Connect the Left and Right AUDIO OUT jacks
from the DVD Recorder + VCR to the left/right
audio in jacks on your TV using the audio cables.
HDMI connection
If you have a HDMI TV or monitor, you can connect it
to this recorder using a HDMI cable.
1 Connect the HDMI jack on the recorder to the
HDMI jack on a HDMI compatible TV or monitor
(H).
2 Set the TV’s source to HDMI (refer to TV’s
Owner’s manual).
Connections
• Be sure to set the DVD Recorder + VCR to
Progressive Scan mode by changing the
‘Video Output’ in the Setup Menu; see page
24.
• Progressive Scan does not work with the RF or
Audio/Video connections.
• When you use the HDMI connection, the
audio’s sampling frequency is outputted only
with 48KHz even if you select [96KHz].
• This recorder does not perform internal (2
channel) decoding of a DTS sound track. To
enjoy DTS multi channel surround, you must
connect this recorder to a DTS compatible
receiver via one of this recorder’s digital audio
outputs.
• No sound will be outputted from HDMI cable if
the Digital out option is not set to ‘PCM’ on the
Setup menu (See page 25).
• The arrow on the cable connector body should
face up for correct alignment with the
connector on the recorder.
• If there is noise or lines on the screen, please
check the HDMI cable.
• When you use HDMI connection, you can
change the resolution (576i, 576p, 720p, 1080i)
for the HDMI output by setting the video output
option in setup menu. (see page 24)
- RGB, Interlaced mode : 576i
- Interlaced mode : 576i, 1080i
- Progressive mode : 576p, 720p
• Changing the Progressive Scan mode when
the recorder is connected with HDMI connector
may result in malfunctions. To solve the
problem, turn off the recorder and then turn it
on again.
Scart Connection
1 Plug a scart cable into the scart socket EURO
AV1 at the back of the DVD Recorder + VCR and
the corresponding scart socket at the back of the
TV set. (V)
2 Plug a scart cable into the blue scart socket
EURO AV2/DECODER at the back of the DVD
Recorder+VCR and the corresponding scart
socket at the back of a satellite decoder or set top
box.
Connecting a TV
Choose one of the following TV connections,
depending on the capabilities of your equipment.
RF Connection
Connect the RF OUT (TO TV) jack on the DVD
Recorder + VCR to the antenna in jack on your TV
using the supplied 75-ohm RF cable (R).
This set doesn’t have a modulator output.
However it still applies the RF through
Output.
ANTENNA
INPUT
Y
Pb
Pr
COMPONENT/PROGRESSIVE VIDEO INPUT
S-VIDEO
INPUT
HDMI
RV
C
H
Rear of DVD Recorder + VCR
Rear of TV
DF-H7DD3D-FB-I(GB) 2007.7.25 2:53 PM ˘ ` 16 mac001 1200DPI 100LPI