Filter
Top Products
-7-
ALIGNMENT INSTRUCTION
2) FOCUS ADJUSTMENT
•
Turn in a local station and adjust the Focus Control knob (located on FBT) for best picture
details at high light condition.
3) RF AGC DELAY ADJUSTMENT (S5)
•
Receive a good local channel.
•
Enter the service mode and select service adjustment S5.
•
You can see the OSD as shown in below.
•
Select RFAGCD item, press the volume up or down button until noise or beat in picture disappears.
•
Press the DISPLAY button to memorize the data.
4) GEOMETRIC ADJUSTMENTS (S6)
•
Enter the service mode and select service adjustment S11.
•
Whenever you select the “S11” using the volume up or down button, the screen is changing like this.
•
Using the volume up or down button, select internal cross pattern.
•
Select service adjustment S6
•
You can see the OSD as shown in below.
4-1. Horizontal Position Adjustment
•
Select H-CENTER item, adjust H-CENTER data value to obtain proper horizontal centering of the
internal cross pattern at the left and right of the screen.
4-2. Vertical Position Adjustment
•
Select V-CENTER item, adjust V-CENTER data value to center the raster properly on the screen.
IF CONTROL
AUTO RFAGC START
RFAGC DELAY 2.0
AGC POINT 3.75
A/D VALUE :9DH
FM/AM PRESCALE 18
SCART PRESCALE 18
MONITOR VOLUME 119
MOVE ADJUST RECALL : SET
NORMAL BLACK WHITE100 WHITE60 CROSS
WVPOS 48
W-VSIZE 22
W-VLIN 12
W-VS 12
W-PCUTION 17
W-TILT 37
W-TOPC 8
W-BOTC 8
H-CENTER 11
V-CENTER 22
V-LIN 12
H-SIZE 32
V-SIZE 96
V-S 12
V-SIZE-C 7
PIN 30
TILT 37
TOP-C 8
BOT-C 8