Filter
Top Products
16
Choose starting point
Select the "Program" function and then
the programme which you want to start
manual tuning. Then, the channel number,
the frequency, If you don’t know the frequency
or channel number then refer to channel
searching section. The name and the programme
number of this programme are displayed in
the install menu.
1
TV system Selection
If necessary, you can change the TV system :
- Select "system" function.
- Choose between :
FRANCE (L/L’), GB (I),
EURO (B/G), E / EURO (D/K) system.
Then, the programme displayed on
screen is changed to the system chosen.
This procedure can be applied to any individual
programme selected.
2
Channel searching
- Select "Freq." function.
- Press the remote control
CURSOR RIGHT / LEFT buttons for more than
3 seconds to start (up / down) manual tuning.
- After searching, tuning will stop automatically
to the next channel.
(To stop searching press the remote control
MENU button)
Note: If you know the channel number or the
frequency of the channel you want to
search, you can set these channels,
entering the data directly into "channel"
or "Freq." setting option.
3
MANUAL CHANNEL TUNING
Fine Tuning
- If you are unable to get a good picture or
sound because of poor reception, it is possible
to fine tune a signal.
- Select channel frequency ("Freq.") function.
- Press and release the remote control
CURSOR RIGHT/LEFT
buttons to fine tune a signal.
4
Enter station name
- Select "name" function.
- Use the CURSOR RIGHT/LEFT
buttons to select the character (letter)
you want to insert.
- To modify this letter press the
CURSOR UP/DOWN buttons until the
desired letter is displayed and press
OK button to confirm.
5
To store a programme in memory
- Select "store to" function
- Adjust the programme number you want to
store and confirm by pressing the remote control
"OK" button. (Program number will breifly turn red!)
Remarks: this function can be used also if you
want to copy a programme already
memorised to another programme number.
Store programmes in memory
6