Filter
Top Products
Dual View Series Service and Installation Manual
2
Delfield
™
®
For customer service, call (800) 733-8829, (800) 733-8821, Fax (989) 773-3210, www.delfield.com
5. Also open the compressor compartment housing and
visually inspect the refrigeration package. Be sure lines
are secure and base is still intact.
6. Freight carriers can supply the necessary damage forms
upon request.
7. Retain all crating material until an inspection has been
made or waived.
Uncrating the Equipment
First cut and remove the banding from around the crate.
Remove the front of the crate material, use of some tools will
be required.
Warning: While uncrating do not lay unit on side.
If compressor is set on side, return to upright
position for 24 hours to allow for all compressor
oil to drain back into compressor.
The serial number is located on the rear of the unit on the
bottom right hand side.
Always have the serial number available when calling for
parts or service.
©2008 The Delfield Company. All rights reserved. Reproduction
without written permission is prohibited. “Delfield” is a registered
trademark of The Delfield Company.
Serial Number Location . . . . . . . . . . . . . . . . . . . . . . . . . 2
Receiving and Inspecting the Equipment. . . . . . . . . . . . 2
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Display Case Glass Replacement . . . . . . . . . . . . . . . . . . 3
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Pressure Control Settings . . . . . . . . . . . . . . . . . . . . . . . 5
Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Replacement Parts Lists . . . . . . . . . . . . . . . . . . . . . . . . 6
Standard Warranties. . . . . . . . . . . . . . . . . . . . . . . . . . . 7-9
Contents
Serial Number Location
Receiving And Inspecting The Equipment
Even though most equipment is shipped crated, care should
be taken during unloading so the equipment is not damaged
while being moved into the building.
1. Visually inspect the exterior of the package and skid or
container. Any damage should be noted and reported to
the delivering carrier immediately.
2. If damaged, open and inspect the contents with the
carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment
notify the carrier. Notification should be made verbally as
well as in written form.
4. Request an inspection by the shipping company of the
damaged equipment. This should be done within 10 days
from receipt of the equipment.
Specifications
Model Length Overall
Depth
Height Shelf
Area
Storage
Capacity
Design
Load
H.P. Volts Amps NEMA
Plug
Ship Weight
536-SR68 36”
(91.4cm)
28”
(71.1cm)
68”
(172.7cm)
19.9ft
2
21.8ft
3
1286 1/2 120 12.0 5-15P 600lbs/272kg
536-SRR68 36”
(91.4cm)
28”
(71.1cm)
68”
(172.7cm)
19.9ft
2
21.8ft
3
1286 N/A 120 5.0 N/A 575lbs/261kg