Filter
Top Products
71
8-7. Initializing the System
Step 3. Signal Strength
Depending on the Dish Type you have selected, the Signal Strength menu shows you up to three sig-
nal strength bars for Satellite Networks A, B, and C, in order to help you adjust the dish to the cor-
rect position with the elevation, azimuth, and tilt values obtained from the Your Location menu.
While the maximum signal strength is 100, there will be no apparent difference in picture quality
between signal strengths of 60 to 85. The higher the signal, the less likely you are to experience pic-
ture quality degradation during adverse weather conditions such as heavy rain or snow.
A transponder is a receiver/transmitter on the satellite. It receives signals from DIRECTV and retrans-
mits them to your dish. The DIRECTV
®
HD Receiver is capable of displaying the signal strength of
most transponders by using the following method.
To see the signal strength:
1. Move the highlight to select the desired
satellite
using “
FG”.
2. Set an each
transponder
using “DE”
3. Press “” to move to the next step of the initial setup.
8. CUSTOMIZATION
NOTE
Depending on your location in the
United States, certain transponders
may not be available. It is normal for
the signal strength level of a few
transponders to be at zero.
NOTE
If you have selected an Oval Dish and
SAT B and/or SAT C do not display a
signal strength on any transponder, re-
check your dish installation or perform
Step 1: Dish Setup again.