Filter
Top Products
15
6 Use the ARROW buttons to move the highlight to the TV1
remote address (the Rem Addr box as shown below). This is
important—if you do not move the highlight, your remote
changes the receiver's TV2 remote address (the Rem Addr
box) and causes your Remote Control 1 to control the TV2 side of
your receiver.
7 Press the RECORD button on the green TV1 remote control you
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning appears, go to
step 15 of this procedure.
8 Select OK using the front panel button to clear the warning
message and return to the System Info screen.
9 On the remote control, press and hold the SAT mode button for
about three seconds, until all the mode buttons light up, and then
let go of the SAT button. The SAT mode button blinks.
10 Use the number buttons to enter any number from 1 to 16, except
for the address shown for on your screen.
Write down the number you entered:
11 Press the POUND (#) button. If you entered the address correctly,
the SAT mode button flashes three times.
12 Highlight the Rem Addr using the ARROW buttons on the
front panel of the receiver.
13 Press RECORD.
14 Make sure the System Info screen shows UHF and that this
address matches the number you entered in step 10.
15 Using the remote, select Done to close the System Info screen. If
nothing happens, use the front panel buttons to highlight the
Rem Addr. Press RECORD, and then select Done.
h
i
Device
Rem Addr
TV Ch Out
3
5
T
UHF
i
Note: Highlight the Rem Addr (the lighter area in the
graphic above) using the ARROW buttons on the remote.