Filter
Top Products
Chapter 10
64
Changing the Program Guide Order
Note
: When both audio signals are present in the program, the receiver default
s to Dolby
Digital output unless you
have selected PCM Only.
Note: If you have selected Dolby Digital Only but there is only PCM a
udio in the program,
you will hear nothing. This also a
pplies to the analog audio outputs.
4
Select one of the following:
• Line Mode. When you use this setting, in comparison to RF Mode, the
dynamic range
is wider, which makes the music and loud noises louder, but voices quiete
r.
• RF Mode
. When you use this setting, in comparison with Line Mode, the dyna
mic
range is narrower, which makes music and loud noises quiete
r, but voices louder.
5
Select Done.
CHANGING
THE
P
ROGRAM
G
UIDE
O
RDER
You can set up the Program Guide to list channels in descending or
der, with the highest
channel number at the top, or in ascending order, with the highest chan
nel number at the
bottom.
Note: If you do not set a channel order, the Program Guide lists the chann
els in
descending order.
1
Press MENU, select Preferences (8), and then Channel Order (5).
2
Select Ascending or Descending.
3
Select Done.