Filter
Top Products
12 DX-WD1201
Need help? Call 800-305-2204
Step 6:
Carefully turn your stand over onto its front edges. Unfold the back (G) and lay it over your stand.
Make equal margins along the side and bottom edges of the back (G). Push on opposite corners of your stand
if needed to make it “square.”
Fasten the back (G) to your stand using the nails (V).
Note: Make sure that you tap nails into the holes that line up over the upright (C) and shelf (F).
Note: Perforations have been provided for access through the back (G). Carefully cut out the holes needed.
Yo u’ l l n e e d :
These holes must line up over the
back edges on the upright (C) and
shelf (F).
Caution: Do not
stand your stand
upright without the
back fastened. Your
stand may collapse.
Do not tap
nails in this
edge
Hammer
V (24)
DX-WD1201_11-0421_MAN_V3_English.fm Page 12 Friday, April 29, 2011 10:57 AM