Emerson LC320EMXF Flat Panel Television User Manual


 
19
EN
INTRODUCTION
PREPARATION
WATCHING TV
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
EnglishEspañol Français
5 Channel List
The channels selected here can be skipped when selecting the channels
using [CH
K
/
L
].
Those channels can still be selected with [the Number buttons].
1
Press [SETUP] to display the main menu.
2
Use [Cursor K
/
L] to select “CHANNEL”, then press
[ENTER].
3
Use [Cursor K
/
L] to select “Channel List”, then press
[ENTER].
Channel
Channel
Autoscan
Channel List
Manual Register
Antenna
4
Use [Cursor K
/
L] to select the channel you want to
remove, then press [ENTER].
Channel List
Channel List
DTV 8
DTV 8
9
9
DTV 48
DTV 48
58
58
DTV 6
DTV 6
27
DTV 67
Ch Select Watch/Skip Back
BACK
ENTER
Highlight channels for Ch
Up/Down key selection.
The channel display for the removed channel
darkens. You will not be able to select the channel
again using [CH
K
/
L
].
To reactivate a removed channel, use [Cursor K
/
L] and
press [ENTER]. The registered channels are highlighted.
When you remove a main channel, its subchannels
are removed as well.
Note:
The channel with the “DTV” indicated on the display is
ATSC. Otherwise the channel is NTSC.
5
Press [SETUP] to exit.
5 Manual Register
This function lets you add the channels that were not added by
the autoscan due to the receptible condition at the initial setting.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K
/
L] to select “CHANNEL”, then press
[ENTER].
3
Use [Cursor K
/
L] to select “Manual Register”, then
press [ENTER].
Channel
Channel
Autoscan
Channel List
Manual Register
Antenna
4
Use [the Number buttons] to enter the number of the
channel you want to add, then press [ENTER].
Manual Register
Manual Register
Register
Ch Change
11
Back
BACK
For analog channels, select a
channel to register using number
keys.
For digital channels, you must
perform Autoscan function.
5
Press [SETUP] to exit.
Note:
If setup completes successfully,
“Added to the channel list” is displayed.
If external input is used, it is not possible to register the
channel and “Unavailable” will be displayed on the TV
screen.
• By using [CH
K
/
L
], you can select the memorized
channels only.