Filter
Top Products
3
EN
INTRODUCTION
PREPARATION
INITIAL SETTING
OPTIONAL SETTING TROUBLESHOOTING
WATCHING TV INFORMATION
17. OBJECT AND LIQUID ENTRY - Never push objects of any kind into
this apparatus through openings as they may touch dangerous
voltage points or short out parts that could result in a re or electric
shock. Never spill liquid of any kind on the apparatus.
18. SERVICING - Do not attempt to service this apparatus yourself as
opening or removing covers may expose you to dangerous voltage
or other hazards. Refer all servicing to quali ed service personnel.
19. DAMAGE REQUIRING SERVICE - Unplug this apparatus from the
wall outlet and refer servicing to quali ed service personnel under
the following conditions:
a. When the power supply cord or plug is damaged or frayed.
b. If liquid has been spilled, or objects have fallen into the apparatus.
c. If the apparatus has been exposed to rain or water.
d. If the apparatus does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions, as improper adjustment
of other controls may result in damage and will often require
extensive work by a quali ed technician to restore the apparatus
to its normal operation.
e. If the apparatus has been dropped or damaged in any way.
f. When the apparatus exhibits a distinct change in performance,
this indicates a need for service.
20. REPLACEMENT PARTS - When replacement parts are required, be
sure the service technician uses replacement parts speci ed by
the manufacturer that have the same characteristics as the original
part. Unauthorized substitutions may result in re, electric shock,
injury to persons or other hazards.
21. SAFETY CHECK - Upon completion of any service or repairs to this
apparatus, ask the service technician to perform routine safety
checks to determine that the apparatus is in proper operating
condition.
22. HEAT - This apparatus product should be situated away from heat
sources such as radiators, heat registers, stoves, or other products
(including ampli ers) that produce heat.
LAMP IN LCD CONTAINS MERCURY, DISPOSE ACCORDING TO LOCAL, STATE OR FEDERAL LAW.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot, fully insert.
ATTENTION: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne
correspondante de la prise et pousser jusqu’au fond.
FCC WARNING
This apparatus may generate or use radio frequency energy. Changes or modifications to this apparatus may
cause harmful interference unless the modifications are expressly approved in the manual. The user could
lose the authority to operate this apparatus if an unauthorized change or modification is made.
RADIO-TV INTERFERENCE
This apparatus has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This apparatus generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this apparatus does cause harmful interference to radio or television reception, which can be
determined by turning the apparatus off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the apparatus and receiver.
3) Connect the apparatus into an outlet on a circuit different from that to which the receiver is connected.
4) Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the
building as close to the point of cable entry as practical.
LOCATION AND HANDLING
• Do not install the unit in direct sunlight, near strong magnetic fields, or in a place subject to dust or strong vibration.
• Avoid a place with drastic temperature changes.
• Install the unit in a horizontal position. Do not place anything directly on top or bottom of the unit. Depending on your external devices,
noise or disturbance of the picture and/or sound may be generated if the unit is placed too close to them. In this case, please ensure
enough space between the external devices and the unit
• Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction.
TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE
• Do not handle the power cord with wet hands.
• Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.
• Do not put your fingers or objects into the unit.
NOTE ABOUT RECYCLING
• This unit’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with
your local recycling regulations.
• Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations
concerning chemical wastes.