Filter
Top Products
Epson is a registered trademark and Livingstation is a trademark of Seiko Epson Corporation. Epson Store and PrivateLine are service marks and
Photo on Demand is a trademark of Epson America, Inc.
General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners.
Epson disclaims any and all rights in those marks.
© 2004 Epson America, Inc. 8/04
Printed in USA
Turning On the TV
1 Plug the TV’s power cord into an electrical outlet. The Power light comes on orange.
2 To turn on the TV, make sure the equipment switch on the remote control is in the TV position.
Then press the Power button.
The Power light flashes green while the TV warms up. Wait for it to stop flashing and remain green.
Turning On the HDTV Tuner
1 Press the TV/Video button on the remote control until COMPONENT1 displays on the screen. This shows that
the HDTV tuner is selected as the input source.
2 To turn on the tuner, slide the equipment switch on the remote control to the STB1 (Set-Top Box 1) position.
Then press the Power button.
3 Wait until you see a message on the screen.
Note
If you see a blank screen or a “No Signal” message, see “Solving Problems” in the far-right column.
4 Press the Menu button, enter the default password (0000), and select Auto Scan to detect local channels.
See the tuner User’s Guide for details.
5 To select a channel, use the Ch +/– button. Or enter a channel using the number buttons and press Ch Enter.
Use the – button to enter digital subchannels (for example, 28–1).
Note
When you want to operate the TV again, slide the equipment switch on the remote control back to the TV position.
Using Photo on Demand
Your TV’s Photo on Demand system lets you view photos on digital photo cards (also called memory cards) or
CD-R/RW discs, print the photos on its built-in printer, and store them on CDs. Follow the quick steps below or the
expanded instructions in your User’s Guide.
Inserting a Photo Card
1 Make sure the TV is turned on, the Power light is green and not flashing, and the Card light is off.
2 Insert your photo card in the appropriate slot on the TV’s front panel. The Card light turns on.
Note
Memory Stick PRO
™
and PRO Duo
™
cards are not supported at this time.
3 After a few seconds, the Photo screen appears. It displays the
photos on your card and outlines the first one in gold:
Note
If the photo viewer doesn’t come up automatically, press the
Photo View button on the TV panel or remote control.
• To select a different photo, press the Prev. <, Next >,
Select , or Select button.
• To enlarge a photo, press the Enter button.
• To zoom into the photo further, press the Photo Zoom +
button. Use the Prev. <, Next >, Select , and Select buttons to adjust the viewing position.
Press Photo Zoom – to zoom back out.
• To rotate a photo, press the Rotate button when the photo isn’t zoomed.
4 Press the Exit button when you’re done.
Viewing a Slide Show
You can view your photos automatically, for a few seconds each, by running a slide show. You can view all the photos or
just selected ones.
1 Press the 2 button on the remote control. The Slide Show
menu on the left of the screen opens:
2 To view all your photos in a slide show, press Enter
to select View Slide Show.
The first photo is enlarged and appears on the screen.
It displays for 3 seconds, then the next photo is displayed.
3 To end the slide show, press Exit.
Selecting a Photo and Printing It
You can print one photo at a time from a digital photo card (memory card) or CD-R/RW.
1 Press Prev.
<, Next >, Select , or Select to highlight the photo you want to print.
2 If you want to print your photo cropped, zoom into it as described above. Only the part you see on the screen will
be printed.
3 Press the Print button on the TV panel or remote control.
You see the Print Settings screen:
4 To print one copy of the photo, press Enter.
To print multiple copies, press Next
> until the number
in the Copies box is correct. Then press Enter. After a
moment, printing starts.
During printing, the Printer light flashes. When printing is
finished, the Printer light turns off.
5 To print additional photos, repeat these steps. You can send multiple photos for printing at one time,
up to 15 photos.
If you see a printing error message, select Yes to check for the problem. Then follow the on-screen instructions to
solve the problem and continue printing. For additional help, see your User’s Guide.
When you’re finished printing, remove the borders from the edges of your photo by bending them back and forth
and tearing them off.
Storing Photos on a CD
Before you save photos on a CD, make sure the external CD-R/RW drive is plugged in and turned on.
Note
Make sure that your disc can be written to at 4X speed. Some high-speed discs don’t support 4X writiing, so check your disc
specifications before inserting it into the drive. See your User’s Guide for additional details on supported discs and formats.
1 Press the eject button on the drive to open the tray.
2 Place a new, blank CD-R/RW disc on the tray with the label
side facing up. Make sure the disc lays flat in the tray.
3 Press the eject button again to close the tray.
Caution
Always use the eject button to open and close the tray. Pushing in
the tray may damage the drive and your disc.
4 Press the 3 button on the remote control to open the
CD-R/RW Writer menu.
5 To write all of the photos on your digital photo card to the
CD, press Enter to select Write to CD-R/RW.
6 You see a confirmation message. Press Enter to select Yes
or press Exit to cancel.
7 You see a writing confirmation message while your photos
are written to the CD and the drive light flashes.
When it’s finished, the CD tray opens and you see a completion message. Press Enter.
Solving Problems
If you have problems setting up your TV, see the suggestions here. For additional troubleshooting advice, see
your TV User’s Guide.
Problem Solution
The power won’t come on. Make sure you slide the equipment switch on the remote control to the TV
position before pressing the Power button. To turn on the HDTV tuner,
slide the switch to the STB1 position.
Make sure your electrical outlet is working and isn’t controlled by a switch
or timer.
Check that the power cord is connected securely.
If the Power light is flashing orange, the TV is cooling down. When it stops
flashing and lights orange, you can unplug it or press the Power button to
turn it on.
If the Power light is flashing green, the TV is warming up. When it stops
flashing and remains green, the TV is ready.
If the Power light is red, you may have a problem with the TV, depending on
the state of the Lamp light. See your TV User’s Guide for details.
The buttons on the TV When the TV is warming up or cooling down (the Power light is flashing),
panel don’t work. you can’t use the buttons. When the Power light stays lit green or orange,
the buttons are operable.
The TV’s fan keeps running The TV cools itself down using internal power even after you turn it off.
when the TV is turned off.
You see a blank screen or a Turn on the video source (HDTV tuner, DVD player, etc.).
“No Signal” message.
Insert a disc or tape, if you’re viewing one, and press Play.
Press the TV/Video button to select the video source.
Check the cable connections.
If you still don’t see an image, see your TV User’s Guide for more
troubleshooting help.
Where To Get Help
Epson provides technical assistance through the World Wide Web 24 hours a day. From the Internet, you can
reach Epson’s product support page at http://support.epson.com. After selecting your product, you can access
troubleshooting information, download product documentation, and receive technical advice through e-mail.
To use the Epson PrivateLine
SM
Support service, call (800) 637-7661 and enter the PIN on the Epson PrivateLine
Support card included with your documentation. This is the fastest way of speaking to a live representative, and it’s
free. This service is available 6
AM to 6 PM, Pacific Time, Monday through Friday, for the duration of your
warranty period.
You may also speak with a TV support specialist by dialing one of these numbers:
• U.S.: (562) 276-4394, 6 AM to 6 PM, Pacific Time, Monday through Friday
• Canada: (905) 709-3839, 6
AM to 6 PM, Pacific Time, Monday through Friday
Toll or long distance charges may apply.
Before you call, please have the following information ready:
• Product name (Epson Livingstation LS47P2 or LS57P2)
• Product serial number (located on the back left side of the TV or on the front of this sheet)
• Description of the problem
You can purchase supplies and accessories from your dealer or from Epson. Call (800) 873-7766 or visit the Epson
Store
SM
at www.epsonstore.com (U.S. sales only). In Canada, please call (800) 463-7766 for dealer referral.
STB1TV
Power
STB2 VCR DVD
Photo View
Menu
Exit
Print
PAUSEREC SKIP
STOP REW PLAY FF
Freeze
Then press Power
Set to TV
CompactFlash
®
card
SmartMedia
®
card
Memory Stick
®
SD/MultiMediaCard
TM
CPD-18297R1
Photo
Zoom
Select
Prev.
Enter
Next
Select
Rotate
132
456
Photo View
Menu
Exit
PrintFreeze
Press Enter to select them
Use arrow buttons to
highlight options
continue
Metal contacts face down