Filter
Top Products
14
FCC Compliance Information
This device complies with FCC Rules Part 15, Operation is subject to the following
two conditions: This device may not cause harmful interference, and this device must
accept any interference received, including interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the manufacturer’s instructions,
may cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: 1) Increase the separation
between the equipment and signal source, 2) Connect the equipment to an outlet on
a circuit different from that to which the signal source is connected, 3) Consult the
dealer or an experienced computer technician for help. The use of shielded cables
for connection of the monitor to the graphics card is required to ensure compliance
with FCC regulations. Changes or modifi cations to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to operate this
equipment.
Macrovision Corporation
This device is protected by U.S. Patent numbers 4.631.603; 4,577,216; and
4,819098 and other intellectual property rights. The use of Macrovision’s Copy Pro-
tection technology in the device must be authorized by Macrovision and is intended
for home and other limited pay-per-view uses only, unless otherwise authorized in
writing by Macrovision. Reverse engineering or disassembly is prohibited.
Software License Agreement
This EVGA software (the “software”) is copyrighted by EVGA CORP and is protected
by US law. All rights reserved. The purchaser is granted a license to use the soft-
ware only, subject to the following restrictions and limitations:
The license is for the original purchaser only, it is transferable so long as all items
bundled with the software are transferred to the same individual as a sale (e.g. all
software, manuals, hardware, etc.)
The original purchaser may use the software on a single computer owned or leased
by the original purchaser. You may not use the software on more than a single ma-
chine, even if you own or lease more than one machine, without the written consent
of EVGA