Filter
Top Products
Low Profile VESA Mount Kit User Guide (Continued)
68-1946-01
Rev A
06 10
Mounting the LPVM-1 to a Mud Ring or UL-Certified Junction Box in Drywall:
NOTE: See the caution on previous page about
weight restrictions.
a. Follow the instructions provided by the manufacturer
to cut the hole and install the mud ring or junction
box.
b. Attach plate 1 to the mud ring or junction box, using
the four #6-32 screws provided. Ensure the tongue is
facing upwards.
c. Connect conduit to the junction box and run the
cables to the installation site.
Mounting the Display Device
5. If necessary, remove all cables from the display device.
NOTE: To VESA mount the TLP 700TV, it is necessary to remove
the base and the plastic enclosure from the back. For
full instructions, see the TLP 700MV and TLP 700TV User
Guide, which is available from www.extron.com.
Do not use the VM 700T for mounting with the LPVM-1.
Use the four 12 mm M4 screws (provided) to attach plate 2 to the
back of the display device, using either the B-type (20 x 50 mm) or
D-type (75 x 75 mm) VESA mounting pattern. The plate should be
attached securely but do not over-tighten the screws.
6. Attach the cables to the back of the display device. Feed any excess
cable back into the wall, conduit, or raceway. Follow all information
in the user manual provided with the display device to ensure the
cables and power are connected correctly.
7. Check the display device is working correctly (see the user manual for the
display device).
8. Hook plate 2 to plate 1 by holding the display at a slight angle so that the
groove of plate 2 is over the tongue in plate 1. Lower the display device so
that the tongue enters the groove as far as possible.
9. Allow the bottom of the display to move inwards so that the display is
parallel to the wall and the bottom tabs of plate 1 are seated over the
bottom edge of plate 2.
10. Lock the two plates together by tightening the two locking screws with a
screwdriver (do not over-tighten).
Plate 2
Monitor w/ B-type
VESA Mount
12 mm M4
Screws (4)
UL-certified
2-gang
Wall Box
#6-32 screws (4)
Extron
LPVM-1
Plate 1
Plate 2
Plate 1
8
9
10
Extron USA - West
Headquarters
+800.633.9876
Inside USA/Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.833.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2010 Extron Electronics. All Rights Reserved. www.extron.com