Filter
Top Products
- 15 -
Error Number
(# of times parking lights flash)
Tach Learning Error Diagnosis
1 Dipswitch #1 is on alternator sensing.
2 Key is in the off position.
3
No signal, or the signal is not fast
enough. Find a different wire
Alternator sensing:
This is not voltage sensing. To use alternator sensing the engine sense input,
(yellow/black) must be connected to the stator wire on the alternator. This will be
a small gauge wire.
Alternator sensing procedure
(To test for alternator sensing set digital multi-meter for DC voltage. Alternator is
pre-programmed in the control module and does not require programming. )
1. The stator wire will rest at 0-volts DC while the vehicle is off.
2. Turn the ignition to the run position with the key. The stator wire will test
between 4 to 6-volts DC.
Start the vehicle with the key. While the vehicle is running at idle the stator wire
will test between 12 to 14-volts DC.
Diagnosing Remote Start Problems
If there is a problem auto-starting the vehicle, you will hear three chirps or see three
parking light flashes when you attempt to auto-start it. Wait for 2 seconds and the cause
for the error will be indicated by the number of times the parking lights flash.
Error Number
(# of times parking lights flash)
Error Reason
1 Engine On
2 Key On
3 Door Open
4 Trunk Open
5 Brake On
6 Hood Open
Reservation Off
7
(Manual Transmission Only)