Filter
Top Products
-3-
LENS LOCK RELEASE
Fig-4
LENS LOCK
4
Remove Lens Protection Cap from the rear (mounting side) of the Projection Lens and attach the
lens Attachment to the lens with 4 Screws. (Use screws attached to the lens.) See Fig. 4.
5
Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 6)
Mount the Lens into the lens mounting bracket and grasp the lens lock lever and turn it counter-
clockwise until the lever is locked. (See Fig. 5 and 7)
After installing the lens, make sure the lens is not loose and properly installed.
Grasp (unlock)
Lens Lock Lever
and pulling
upward.
Grasp (unlock) Lens
Lock Lever and fully
pulled downward until it
is locked (clicked).
Fig-6
Fig-7
LENS ATTACHMENT
Lens Attachment 01
POA-LNA-01
(610 303 8742)
Part No. (610 275 6029)
DRIVER INCLUDED
IN THE LENS PACKAGE
LENS LOCK
LEVER
Fig-5
LENS INSTALLATION NEEDS TWO OR MORE PEOPLE.
TO INSTALL THE LENS BY A SINGLE PERSON MAY RESULT IN A SERIOUS DAMAGE
ON THE LENS OR THE PROJECTOR BY DROPPING OR BUMPING THE PRODUCTS.
6
Set up the projector and project image on the screen. Turn the lens part "A" to adjust ZOOM. Turn
the lens part "B" to adjust FOCUS.
Turn the lens part "A"
to adjust ZOOM.
Turn the lens part "B"
to adjust FOCUS.
A
B
LENS MOUNTING
BRACKET