Fisher SRT-7072 VCR User Manual


 
CONNECTIONS
Connect the video camera and monitor TV as shown in the figure below.
NOTE: Before making the connections, make sure the devices are disconnected from the power outlet.
AUDIO
OUT
MIC IN
REMOTE
PUSH
OPEN
EXT
TIMER IN
AC IN ~
IN
VIDEO
IN OUT
RS485
BA
COM
WARNING
OUT
TAPE
END OUT
SW
OUT COM OUT IN
ALARM
OUT IN
SERIES OUT/
NON REC OUT
SERIES
IN COM
TIMER
OUT OUT IN
EJECTCLOCK SET
RS232C
ADDRESS
ON
OFF
485
232
TERMINATE
ON
OFF
To remote control
(sold separately)
Video camera
(sold separately)
Monitor TV (sold separately)
Coaxial cable
(sold separately)
To
VIDEO IN
jack
To
VIDEO
OUT
jack
From an external
audio source
Power cord
To outlet
Power Cord Installation
1 Plug the supplied power cord firmly into the AC power
input AC IN ~ socket.
2 Insert the plug of this power cord into a outlet.
About the memory reset
If the VCR location is changed or to cancel previous
settings, please reset the memory as described below.
All the settings as the time and date will be reset, and the
security lock will be cancelled.
To reset the memory, press the ALL RESET button.
NOTES:
œ For more details, please refer to the manuals
accompanying all other devices. If the connections are
not made properly, it may cause a fire or damage the
equipment.
œ You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
œ The grounded power cord (3 pin plug) must be
connected to a grounded power outlet.
œ If there is no video signal when the power is turned on,
“NO VIDEO” will be displayed on-screen.
RC4QR/U3 (SRT-7072 GB) Tue. June, 29/1999
6 English