Fujitsu P42HHA40A Flat Panel Television User Manual


 
E-33
EnglishDeutschEspañolFrançaisItalianoPortuguês
日 本 語
Póññêèé
中文
Minimizing phosphor burn-in (Screen Orbiter) for RGB
You can use this option to move the screen position to minimize phosphor-induced “burn-in”.
Follow the steps below.
(1) Select “Screen Orbiter” and press
<.
The “Screen Orbiter” setting screen will appear.
(2) Press
C or D to select “Mode/Time”.
(3) Select a desired pattern.
Each time you press E or F, one of the available choices appears in the following sequence:
[Off]: Disables Screen Orbiter.
[Time]: Moves the pattern approximately every one hour.
[Mode]: Moves the pattern when the power is turned ON or when you switch between modes.
(4) Press
C or D to select “Moving Area”.
(5) Press
E or F to select the range for moving the pattern.
Each time you press E or F, one of the available choices appears in the following sequence:
[Min.]: Pattern moves in small range. (About 5 pixels)
[Std.]: Pattern moves in moderate range. (About 10 pixels)
[Max.]: Pattern moves in wide range. (About 15 pixels)
(6) Press
< to store.
* When the Screen Orbiter function is operated, some letters at the top, bottom, right or left of the
screen may be missed.
Setting RGB Input Signal Compulsorily (Direct Setting) for RGB
You can use this option to switch the setting for RGB input signal.
Each time you press
E or F, one of the available choices appears in the following sequence:
[Auto]: The optimum display is obtained automatically for input signals.
[Others]: The optimum resolution setting is fixed for each signal.
Press < to store.
* In Auto mode, the resolution of VGA, WVGA, 480P, XGA, WXGA, SXGA and SXGA
+
may not be
automatically distinguished. Switch to the fixed display when the image is not displayed properly.
* Signals that are not applicable depending on the model or input terminals may not be displayed.
Specifying RGB Input Signal (Code Setting) for mD-sub input
Normally, use this option in Auto mode.
Displaying white over entire screen (White Screen)
You can use this option to display white over the entire screen to minimize phosphor burn-in.
Each time you press
E or F, one of the available choices appears in the following sequence:
On < Off
Press
< to store.
“Screen Orbiter” setting screen
Note
The screen display disappears if there is no operation within approximately 60 seconds.
Depending on the model or the optional devices, some of the functions may not be available.
The adjustment range varies according to the display signals. Make adjustments to your preferred Sharpness within the adjustment range.
Depending on the type of signal, it may not be possible to make some of the settings or adjustments.
MHD01661-01_E.book 33 ページ 2004年11月16日 火曜日 午後4時33分
Downloaded From TV-Manual.com Manuals