Filter
Top Products
E-2
INFORMATION
• Receptacle
Make sure that the power cord’s grounding wire is grounded.
The plasma display comes with a 3-prong power plug; one prong is connected to the grounding wire. If you have only a 2-hole
receptacle, you will need to have it replaced. Contact your dealer for more information.
• Have the plasma display inspected and cleaned by your dealer at regular intervals.
• Pictures may become “burn-in” into the screen phosphors if the screen left on with same picture or pattern for extended periods of time.
To ensure that the plasma display has a prolonged service life, be sure to use settings such as the screen orbiter or white screen settings.
These settings will ensure that the same picture or pattern is not constantly displayed for long periods. (See P. E-42 )
• High-precision technology has been used in the manufacture of the plasma display panel, in which the effective pixels exceeds 99.99%.
However, please be aware, that fewer than 0.01% of the pixels may be missing or remain constantly lit.
• Some models are fitted with a radiator fan to prevent the plasma display’s internal temperature from rising during operation. Be careful
of the air emitted by the radiator fan, as it may be hot.
• Contact your dealer when causing a bad influence to the plasma display and other audio-visual equipment mutually.
You may need to move your plasma display if it produces degraded pictures or noise due to electromagnetic radiation, or if the infrared
remote control does not function properly.
• Pictures may not be displayed properly if you connect a non-standard PC to the RGB input terminal. In this case, contact your dealer for
more information.
• The protective circuit, built into the display, automatically turns off the power if the display has a problem. In this case, you will see that
the power indicator lamp flashes red or green.
• It is important to install the plasma display in a location close to a receptacle, and where the emergency stop button can be easily
reached.
Warning
If the power indicator lamp flashes red or green, this signifies that the display has developed a problem. When this happens, be sure to unplug from the
receptacle to prevent fire or electric shock. Then contact your dealer.
Note
• Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products.
• In order to facilitate the explanations, pictures and diagrams in this manual may differ slightly from the actual items.
MHD01862_E.book 2 ページ ２００５年１１月２５日 金曜日 午後８時５４分
Downloaded From TV-Manual.com Manuals