Fujitsu P-TU5051E Flat Panel Television User Manual


 
E-42
OTHER ADJUSTMENTS (Continued)
Minimizing phosphor burn-in (Screen Orbiter) for RGB
You can use this option to move the screen position to minimize phosphor-induced “burn-in”.
Follow the steps below.
(1) Select “Screen Orbiter” and press
<.
The “Screen Orbiter” setting screen will appear.
(2) Press C or D to select “Mode/Time”.
(3) Select a desired pattern.
Each time you press E or F, one of the available choices appears in the following sequence:
[Off]: Disables Screen Orbiter.
[Time]: Moves the pattern approximately every one hour.
[Mode]: Moves the pattern when the power is turned ON or when you switch between modes.
(4) Press C or D to select “Moving Area”.
(5) Press E or F to select the range for moving the pattern.
Each time you press E or F, one of the available choices appears in the following sequence:
[Min.]: Pattern moves in small range. (About 5 pixels)
[Std.]: Pattern moves in moderate range. (About 10 pixels)
[Max.]: Pattern moves in wide range. (About 15 pixels)
(6) Press < to store.
* When the Screen Orbiter function is operated, some letters at the top, bottom, right or left of the
screen may be missed.
Setting RGB Input Signal Compulsorily (Direct Setting) for RGB
You can use this option to switch the setting for RGB input signal.
Each time you press
E or F, one of the available choices appears in the following sequence:
[Auto]: The optimum display is obtained automatically for input signals.
[Others]: The optimum resolution setting is fixed for each signal.
Press
< to store.
* In Auto mode, the resolution of VGA, WVGA, 480P, XGA, WXGA, SXGA and SXGA
+
may not be
automatically distinguished. Switch to the fixed display when the image is not displayed properly.
* Signals that are not applicable depending on the model or input terminals may not be displayed.
Specifying RGB Input Signal (Code Setting) for mD-sub input
Normally, use this option in Auto mode.
Displaying white over entire screen (White Screen)
You can use this option to display white over the entire screen to minimize phosphor burn-in.
Each time you press E or F, one of the available choices appears in the following sequence:
On < Off
Press < to store.
“Screen Orbiter” setting screen
MHD01862_E.book 42 ページ 2005年11月25日 金曜日 午後8時54分
Downloaded From TV-Manual.com Manuals