FUNAI DVC860D DVD VCR Combo User Manual


 
6 After scanning, the tuner stops on the low-
est memorized channel.The TV screen
returns to TV mode.
¡If AUTO SET UP appears on the TV screen again,
check the cable connections. Press B once again and
the VCR will begin preset again.
16
EN
1L25
AUTOMATIC CHANNEL SET UP
SETUP
You can automatically program the tuner to scan only
the channels you receive in your area.
¡Channel memory programming is NOT needed
when you connect the VCR to a cable box or a satel-
lite box as in "CONNECTING TO ATV WITHOUT
A/V TERMINALS" on page 13. In this case, select
channel 3 on your TV. Then, the channel you want to
record or view may be selected at the cable box or
satellite box.
¡If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback. Then select the same chan-
nel (CH4) on your TV.
¡Follow the steps below once. Repeat only if there
is a power failure or if the VCR is unplugged for
more than 30 seconds. (In these cases, the pro-
grammed channels are erased.)
¡You must follow the steps below before attempting
to play or record a video tape. If you want to play
or record a video tape BEFORE programming the
tuner, you can cancel it by pressing
CLEAR/C.RESET.
1 You need to connect the antenna or cable to
the VCR first.Then, connect the DVD /VCR
power plug to a standard AC outlet.
2 Turn on the TV and set the TV to channel 3.
¡If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback. Then select the same chan-
nel (CH4) on your TV. (See RF OUTPUT
CHANNEL on page 13 for the detail.)
3 Turn on the VCR by pressing POWER. the
POWER light will come on.
4 Select the On Screen Language (ENG-
LISH, FRANCAISor
ESPAÑOL) by pressing
K
or L. Then, press B.
5 Begin channel preset by pressing B once.
The tuner scans and memorizes all active
channels in your area.
¡The VCR distinguishes between
standard TV channels and cable
channels.
VCR
TO SELECT A DESIRED CHANNEL
You can select the desired channel by using CHAN-
NEL (o/p) or by directly pressing Number on the
remote control.
Note for using the Number:
¡When selecting cable channels which are higher
than 99, enter channel numbers as a three-digit num-
ber.(For example: 117, press 1,1,7)
¡You must precede single-digit channel numbers with
a zero (For example: 02, 03, 04 and so on).
TO PRESET THE CHANNELS AGAIN
1 Press MENU until the main menu appears.
(If you have already set the clock, you only
have to press it once. If not, you have to
press it twice).
2 Select CHANNEL SET UP by pressing K
or L.Then, press B.
3 Select AUTO SET UP by pressing K or L.
Then, press
B.
¡After scanning, the tuner stops on the lowest memo-
rized channel.
AUTO SET UP
CH 01
H9400UD(EN)2î.qx33 03.2.18 5:48 PM Page 16