Filter
Top Products
13
EN
WATCHING TV
INTRODUCTION
CONNECTION INITIAL SETTING OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Switching Each Mode
You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access an external device when they are connected to the unit.
Press [DTV/TV] repeatedly to change the analog TV or
the digital TV.
DTV
/
TV
ANALOG MODE
DIGITAL MODE
Note:
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. The following TV screen is displayed while
switching the mode.
NOW SCANNING
Press [INPUT SELECT] repeatedly to cycle through the
input modes.
INPUT
SELECT
ANALOG MODE
DIGITAL MODE
VIDEO1
VIDEO2
COMPONENT
• To use the video (rear) or S-video input jack on the
unit, select “VIDEO1”.
• To use the video (front) input jack on the unit, select
“VIDEO2”.
• To use the component video input jack on the unit,
select “COMPONENT”.
5 Switching Audio Mode
This section describes how to switch the audio in the analog mode and how
to switch the audio language in the digital mode.
TV
While receiving an MTS broadcast, press [AUDIO]
repeatedly to cycle through the available audio
channel.
AUDIO
MAIN
SAP
MONO
MAIN : Outputs main-audio
SAP : Outputs second audio program
MONO : Outputs mono-audio
• The information display will automatically disappear
in a few seconds.
DTV
1
Press [AUDIO] to display the currently selected
language and the number of available languages.
AUDIO
KABC CH 95-03
A Day of Memories
ENGLISH 1/3
2
Press [AUDIO] repeatedly to cycle through the
available audio languages.
AUDIO
• Available languages differ depending on the
broadcast. “OTHER” is displayed when the audio
language cannot be acquired, or the acquired languages
are other than English, Spanish or French.
• The information display will automatically disappear
in a few seconds.
Note:
• Pressing [AUDIO] does not control external audio device.
5