Filter
Top Products
34
EN
T
ROUBLESHOOTING
Question Answer
My remote control does not work. What
should I do?
Check the antenna or cable connection to the main unit.
Check the batteries of the remote control.
Check if there is an obstacle between the infrared sensor window and the
remote control.
Test the signal output. If OK, then possible infrared sensor trouble.
(Refer to “IR Signal Check” on page 35.)
Aim the remote control directly at the infrared sensor window on the front
of the unit.
Reduce the distance to the unit.
Re-insert the batteries with their polarities (+/– signs) as indicated.
When there is an infrared-equipped device such as PC near this unit, it
may interrupt the remote control signal of this unit.
Move the infrared-equipped device away from this unit, change the angle
of the infrared sensor or turn off the infrared communication function.
•
•
•
•
•
•
•
•
How come the Initial setup appears every
time I turn on this unit?
Connect the RF cable to the unit directly and run the initial setup.
Make sure to complete the channel scan before turning off the unit.
•
•
Why I cannot watch some of TV programs?
Make sure auto channel scan has been completed.
(Refer to “Auto Channel Scan” on page 14.)
Auto channel scan must be completed when you set up the unit for the
first time or move it to a location where previously unavailable channels
are broadcast.
The selected channel may not be broadcasting.
When auto channel scan is interrupted and not completed,
some channels will not be received. Make sure to complete.
(Refer to “Auto Channel Scan” on page 14.)
The selected channel cannot be viewed by the V-chip setting.
(Refer to “V-chip” on page 28.)
The unit requires some kind of antenna input. An indoor antenna (rabbit
ears), an external antenna, or an RF coaxial cable from your wall or cable
/satellite box needs to be plugged into the unit.
•
•
•
•
•
•
How come there is no image from the
connected external devices?
Check if the right input mode is selected by pressing [INPUT SELECT] or
using [CH
K
/
L
]. (Refer to “Switching Each Input Mode” on page 16.)
Check the antenna or cable connection to the unit.
•
•
Whenever I entered channel number,
it changes automatically.
Many digital channels have alternate channel numbers. The unit changes
the numbers automatically to the ones signifying the broadcasting
stations. These are the numbers used for analog broadcasts.
•
Why are captions not displayed entirely?
Or, captions are delayed behind the
dialogue.
Captions that are delayed a few seconds behind the actual dialogue are
common for live broadcasts. Most captioning production companies can
display a dialogue to maximum of 220 words per minute. If a dialogue
exceeds that rate, selective editing is used to insure that the captions
remain up-to date with the current TV screen dialogue.
•
How can I set the clock ? There is no clock function on this unit.
•
FAQ5