GE CRT Television CRT Television User Manual


 
10
Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2–13 appear in the TV’s memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
A. Hook up an antenna, cable or
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU repeatedly to
select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press VOLUME + to start the
TV adding all active channels
into memory.
D. Wait until the TV has cycled
through all the channels and
returns to the original channel.
1. Place channels in
memory (Autoprogram)
2. Add or delete channels
A. Press MENU repeatedly to
select the Setup menu. This
menu is white.
B. Press CHANNEL down to
highlight Channel Memory.
C. Press VOLUME + to underline
the channel number.
D. Select the channel number you
want to add or delete with the
number buttons.
E. Press VOLUME + to add or
delete a channel (you will see
Stored on the screen when
added and Erased when
deleted).
F. Repeat D and E for more
channels.
13
Controls Alarm Adjust Setup
Autoprogram
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
Autoprogram
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
Autoprogram
Channel Memory: 13
Erased
Cable/Air: Cable
15
Controls Alarm Adjust Setup
Autoprogramming
Channel Memory: 13 Stored
Cable/Air: Cable