Filter
Top Products
6
How to Connect the DVI DL to HDMI Converter
1. Connect up to 4 DVI dual link source devices to the DVI DL to HDMI
Converter’s DVI inputs. 4 DVI DL cables are supplied.
2. Connect up to 4 HDMI capable displays to the DVI DL to HDMI Converter’s
HDMI outputs. 4 HDMI cables are supplied.
3. Connect the supplied 24V DC power supply to the DVI DL to HDMI
Converter. Plug the power cable into a power source.
How to Operate the DVI DL to HDMI Converter
Once all input and output devices are connected and power has been applied,
the DVI DL to HDMI Converter should be on. Once the source devices and
output devices are properly linked, the front panel LED’s should become active.
The rear panel carries sets of switches to enable 10-bit and 12-bit deep color.
A Master Switch must be enabled per input to activate these extended color
modes. When the master switch is in the OFF position, 8-bit color is enabled.
To use 10-bit and 12-bit color modes, please set the Master Switch to the
ON position. This must be done for each input that will use the extended color
modes.
Once the Master Switch is set to ON, use the 10-bit/12-bit selector switch to
enable the desired color mode.
Changes are immediate and do not require a system reset. If a reset is required,
please press the RESET button located on the front panel.
CONNECTING AND OPERATING THE DVI DL TO HDMI CONVERTER