Filter
Top Products
5
1 Reset Button
This button will cycle power on the 1:10 Splitter For HDMI 1.3. If the EDID mode
has been changed it will not take effect until the unit has been reset.
2 Activity Indicator
This LED indicator will turn bright blue when an input signal is detected.
3 Power Indicator
This LED indicator will become active once the included 5V DC power adapter
has been properly connected.
4 EDID Selection Switch
Switches between the built-in Internal EDID and External (Pass-Through) EDID.
5 HDMI Input Port
Connect an HDMI or DVI (with a DVI to HDMI adaptor or cable) source device
to this input port.
6 HDMI Output Ports 1 - 10
Connect up to 10 HDMI or DVI (with a HDMI to DVI adapter or cable) displays to
these output ports. The display connected to the port labeled OUT 1 will have its
EDID used when the external mode is active.
7 24V DC Power Input
Connect the included 24V DC power supply to this port.
PANEL DESCRIPTIONS