Gefen GTV-ETH-2COAX Flat Panel Television User Manual


 
12
CONFIGURING THE GEFENTV ETHERNET OVER COAX
Once both the sending and receiving units are linked and powered, basic
con guration can proceed. This section of the manual refers to the sending unit
as the LOCAL NODE, and the receiving unit as the REMOTE NODE.
NOTE: The following steps are for manual con guration of the nodes for a
basic secure network. These steps are optional, as the nodes will function with
their default settings. However, for security and performance purposes, it is
recommended that the following steps be performed. Automatic con guration is
also possible using the Automatic Security Con guration feature on page 17 in
lieu of the procedure outlined in this section.
Ensure that both the local and remote nodes are powered and are properly 1.
linked.
Con rm that the computer with the installed GefenTV Ethernet Over Coax 2.
software is connected to the local node.
Start the 3. Gefen TV Con g Tool from this location:
Start Menu \ All Programs \ GefenTV Ethernet Over Coax \ Gefen TV Con g Tool
The introduction screen should appear as the image below. Click on the next 4.
button to continue.
The program will begin to search for all connected nodes.5.