Filter
Top Products
12
Connections (Continued)
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your existing equipment.
RF coaxial connection
Connect the RF.OUT jack on the DVD+VCR to the
antenna in jack on your TV using the supplied 75-ohm
coaxial cable (R).
ote
If you use this connection, tune the TV to the
DVD+VCR’s RF output channel (CH 3 or 4).
How to set the DVD+VCR’s RF output channel
1.While the DVD+VCR is turned off,
press and hold CH
(v/V) on the front panel for about five seconds.
The unit will turn itself on and “RF 03” or “RF 04” appears on
the front panel display.
2.
Use CH (v/V) on the front panel or CH (v/V) on the
remote control to change the RF output
channel (CH 03 or CH 04).
3.
Turn the DVD+VCR off and then on.
4.
Set the TV to channel 3 or 4 depending on the RF
output channel you selected.
Now you can watch the DVD+VCR playback on CH3
or CH4 of your TV.
Audio/Video connection
11
Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on your TV using the
supplied video cable (V).
22
Connect the Left and Right DVD/VCR AUDIO OUT
jacks on the DVD+VCR to the audio left/right in
jacks on your TV (A1) using the supplied audio
cables.
ote
If you use this connection, set the TV’s source selector
to VIDEO (sometimes referred to as Line, Aux, Input,
etc.).
L
R
AUDIO INPUT
VIDEO
INPUT
ANTENNA
INPUT
A1 VR
DVD+VCR Connections Panel
TV Connections Panel