Filter
Top Products
10
The Setup Menu
Video
Aspect Ratio The ratio of the width of an image to its height.
• 4:3PS The 4:3PS (Pan & Scan) ratio shows the DVD movie in full screen, but the sides of the
movie are cut away so that it ts on a standard TV screen
• 4:3LB The 4:3LB (Letterbox) ratio shows the DVD movie in a original format, but with black
bars at the top and bottom so that it ts on a standard TV screen.
• 16:9 The 16:9 ratio shows the DVD movie in its widescreen format. Use this setting when view-
ing a movie on a widescreen TV.
View Mode Select the View Mode to adjust the DVD’s image proportions on the TV screen. Choose
between Fill, Original, Height Fit, Width Fit, Auto Fit, or Pan Scan.
TV System Select the TV system that’s consistent with the connected television. NTSC is the standard
TV System setting for the U.S.A., Canada, and Mexico.
Video Out
• S-Video Select the S-Video option to use the S-Video Output as the unit’s primary video output.
• YUV (Composite Video Out) The Setting is an advanced setting that takes advantage of the
Composite Video Outputs.
• P-Scan (Component Video Out The P-Scan (Progressive Scan) setting is an advanced setting
that takes advantage of the Component Video Outputs, and produces a higher quality image output.
• Press the Video button on the remote control to cycle through S-Video, YUV, and P-Scan.
Smart Picture Use the Smart Picture options to improve the image quality of a DVD. Choose from Stan-
dard, Bright, Soft, or Dynamic.
Audio
Digital Output
• Off The Off setting is used when the Digital Audio Output is disconnected.
• PCM The Digital Audio Output must be connected to a surround sound receiver to fully take
advantage of this feature.
• RAW The RAW setting will automatically enable PCM in circumstances where it can be used,
and automatically disable it when it cannot be used. Like PCM, this option also requires the Digi-
tal Audio Output to be connected to a surround sound receiver.
Misc
Use Default Settings The Use Default Settings button will change all settings back to the original factory
defaults.
Screen Saver The Screen Saver should be turned on to avoid burn-in on the television.