Filter
Top Products
8
Setup
Requires a TV antenna (not included).
1. Connect a VHF, UHF, or HDTV antenna to the RF
INPUT on the television.
2. Press the SOURCE button to switch to TV mode.
3. Press the MENU button to access the setup
menu.
4. Press the ARROW () buttons to highlight the
CHANNEL icon. Press the ENTER button.
5. Press the ARROW () buttons to highlight
SIGNAL TYPE. Press the ARROW () buttons
to select AIR.
6. Press the ARROW () buttons to highlight
AUTO CHANNEL SEARCH. Press the ENTER
button to begin scanning for available channels.
Requires a cable connection.
1. Connect a cable to the RF INPUT on the
television.
2. Press the SOURCE button to switch to TV mode.
3. Press the MENU button to access the setup
menu.
4. Press the ARROW () buttons to highlight the
CHANNEL icon. Press the ENTER button.
5. Press the ARROW () buttons to highlight
SIGNAL TYPE. Press the ARROW () buttons
to select CABLE.
6. Press the ARROW () buttons to highlight
AUTO CHANNEL SEARCH. Press the ENTER
button to begin scanning for available channels.
The Auto Channel Scan must be run before any channels can be viewed on the television.
1. Press the SOURCE button to switch to TV mode.
2. Press the MENU button to access the setup menu.
3. Press the ARROW () buttons to highlight the CHANNEL icon. Press the ENTER button.
4. Press the ARROW () buttons to highlight SIGNAL TYPE. Press the ARROW () buttons to select AIR.
5. Press the ARROW () buttons to highlight AUTO CHANNEL SEARCH. Press the ENTER button to begin
scanning for available channels.
Connecting a TV Antenna
Connecting a Set-Top Box
Connecting Basic Cable
Auto Scanning for Channels
Requires a Set-Top Box (not included).
If your Set-Top Box has an HDMI Output:
• Connect the HDMI output on the Set-Top Box to the HDMI INPUT on the television using an HDMI cable
(not included).
If your Set-Top Box has a Composite Video Output:
• Connect the video output on the Set-Top Box to the COMPOSITE VIDEO INPUT on the television using
an A/V RCA cable (not included). Connect the audio output on the Set-Top Box to the RCA AUDIO INPUT
on the television.
If your Set-Top Box has a Component Video Output:
• Connect the component video output on the Set-Top Box to the COMPONENT VIDEO INPUT on the
television using a component RCA cable (not included). Connect the audio output on the Set-Top Box to
the RCA AUDIO INPUT on the television.
After connecting your Set-Top Box:
• Press the SOURCE button to switch to YPBPR, AV, or HDMI to match the connection used.