Filter
Top Products
Installation
16 313259D
10. Slide Viscon HP heater (A) into slots on frame.
Tighten bolts to secure to frame.
11. For heating hoppers or heating hoppers and
heated hose: install fitting (18) and elbow (17) in
the heater’s fluid inlet facing away from the system.
Install elbow (7) in heater outlet facing the back of
the system.
12. For heating heated hose only: connect elbow fit-
ting (17) to heater fluid inlet facing the back of the
system. Install elbow (7) in the heater outlet facing
upward.
13. Wire Viscon HP heater (B) to your voltage supply.
Follow wiring procedure in the Viscon HP manual
309524.
14. If heating hoppers:
a. Remove bottom plug (P) from hopper (C).
b. XP Kit 24M224 only: Install nipple (33) and
coupling (139) into bottom of hopper. See
page 24.
c. Install elbows (32) and fittings (31).
d. Repeat for second hopper.
15. Remove side plug (P) used for fluid inlet.
16. Replace plug with bushing (11) and elbow fitting (7).
17. Cut tubing (4, 16, 29). See Tubing Lengths on
page 14.
NOTE:
Fitting nuts may need retightening as the system
reaches normal operating temperatures.
F
IG. 8
F
IG. 9
A
r_256273_313259_7
XM Kit 256273 XP Kit 24M224
ti19156a
A
r_256273_313259_16a
18
17
7
r_256273_313259_17a
17
All wiring must be done by a qualified electrician. See
warnings, page 3.
P
P
711
32
C
r_256273_313259_8
31
XM shown