Filter
Top Products
2 332981A
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-
tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When
these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific
hazard symbols and warnings not covered in this section may appear throughout the body of this manual where
applicable.
Additional Roller Covers
The following MAGNUM pressure roller covers are
available at your local distributor:
243063 9 in. (23 cm) 1/2 in. (13 mm) nap
243064 9 in. (23 cm) 3/4 in. (19 mm) nap
243065 9 in. (23 cm) 1-1/4 in. (32 mm) nap
WARNING
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury. To help prevent injury:
•
Do not modify the extension tube or roller frame or use parts not designed for this equipment.
•
Do not use 1,1,1--trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids con-
taining such solvents in this or any other pressurized aluminum equipment. Such use could result in a chemical
reaction, with the possibility of explosion.
FIRE AND EXPLOSION HAZARD
Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in a fire or
explosion and serious injury. To help prevent injury from fire or explosion:
•
Provide fresh air ventilation to avoid the buildup of flammable fumes from flushing fluids or the coating being
applied.
•
Keep the application area free of debris, including solvent, rags, and gasoline.
FLUID INJECTION HAZARD
If high-pressure fluid pierces your skin, the injury might look like “just a cut”. But it is a serious wound. Get immediate
surgical treatment. To help prevent injection:
•
Keep your hands and body away form the roller frame when flushing. High pressure fluid emitted from the holes
in the frame could cause an injection injury.
•
Always relieve pressure before you check or repair leaks and when you turn off pump or stop painting.
•
Never use components rated less than system Maximum Working Pressure.
ELECTROCUTION HAZARD
Failure to observe the electrical hazards described below could result in serious injury, including burns or electrocu-
tion. To help prevent harmful electrical shock
•
Avoid contact with power lines.
•
Follow all grounding instructions in your separate pump and gun instruction manual, and comply with all local,
state, and national fire, electrical, and safety regulations.
•
Use only MAGNUM or Graco paint hoses.