Grizzly G8146Z TV Video Accessories User Manual


  Open as PDF
of 72
 



Cutting Overview
ELECTROCUTION HAZARD
This bandsaw is not designed to be used
with water soluble cutting fluid or coolant.
If needed, use a small amount of oil-based
lubricant.
Always disconnect power
to the machine when
changing blades. Failure
to do this may result in
serious personal injury.
All saw blades are dan-
gerous and may cause
personal injury. To reduce
the risk of being injured,
wear leather gloves when
handling saw blades.
Blade Changes
To replace the blade:
1. 
2. 
3. 

4.        
      

5. 


      

       







         












Workpieces that cannot be supported or
stabilized without a vise or jig should not
be cut on a vertical metal-cutting bandsaw,
because they can unexpectedly move while
cutting and draw the operator's hands into
the blade causing serious personal inju-
ry. Examples are chains, cables, round or
oblong-shaped workpieces, workpieces
with internal or built-in moving or rotations
parts, etc.
 previous next