Haier 24D2000 Flat Panel Television User Manual


 
11
INITIAL SETUP
will guide you through setting up basic settings
including the menu language, time zone, and TV
signal source.
1. Press to turn on the TV. The setup wizard screen
opens. Press OK to start the wizard.
3. Press to select your language, then press
to continue.
4. Press to select your time zone, then press
to continue.
5. Press to select your tuner type, then press
to start channel scan.
Air – Set the signal type to antenna. When set to
Air, the TV can receive analog and digital (ATSC)
broadcasting signals.
Cable – Set the signal type to cable. When set to
Cable, the TV can receive analog and QAM
broadcasting signals.
6. The auto channel scan usually takes a few minutes
to complete but can take up to 20 minutes. You can
cancel the channel scan by pressing
EXIT.
During initial setup, press to return to the previous
screen and press EXIT to exit the initial setup.
INPUT SOURCE
Press INPUT to open the input source list, then press
to highlight an input and press OK to
switch.
egaugnaLputeS laitinI
Please select your preferred language
English
Français
Español
Back Select Next Exit
puteS laitinI
Home mode
Store Mode
Back Select Next Exit
enoZ emiTputeS laitinI
Back Select Next Exit
Newfoundland
Atlantic
Eastern
Central
Pacific
Alaska
Hawaii
Samoa
Mountain
renuTputeS laitinI
Air
Back Select Next Exit
Cable
nacS lennahCputeS laitinI
Cancel Exit
The channel scan may take a while to complete.
Analog: 0
Digital: 0
RF CH: 30
Total Found: 0
20%
NOTE
2. Press to select
Home Mode or Store Mode
,
then press to continue.
Note: Home mode is energy saving mode, store mode
is vivid mode.
NAVIGATING THE ON-SCREEN MENU
1. Press MENU to open the on-screen menu.
2. Press to select the main menu (Picture/
Audio/Channel/Setup/Lock), then press OK or
to enter the sub-menu.
3. Press to highlight a sub-menu item, then
press to adjust the setting or select the
desired option.
4. Press EXIT to close the on-screen menu.
Press MENU to return to the previous menu. If the main
menu is displayed, pressing MENU will close the on-
screen menu.
NOTE