Haier HL19R1 Flat Panel Television User Manual


 
1.1.Supporting media and file format:
Digital pictures (.JPG) and digital
music (.MP3) files
Due to differences in the file code and
file mode, It is possible that some
files cannot be read.
2.Before starting operation, verify
USB storage device is of FAT32 and
FAT file system format. At present,
this television does not support NTFS
and the file systems of other format.
3.External card reader supports most
digital cards available in the market.
Readable digital cards are classified
according to the property of card
readers and can be connected to
mobile hard disks (working voltage
5.0V, working current not over 500mA).
4.The television operation may be
halted due to excessive rate of
information code errors. In such case,
restart the system. Please note -
there are many nonstandard USB
mobile devices in the market. If a
nonstandard device is used then an
identification problem may occur.
USB Input
To play picture
1.Press USB button on the remote to
enter stream media system.
The system start up takes about 3
second. Then insert the USB drive
in the USB input.
2.Press button to select Picture
. Press ENTER to enter.
3.Press / button to select
desired picture, and then press
ENTER button to enter the play
interface.
4.Press the button on the remote control
to select the adjusted item, press
ENTER button to confirm.
5.Press EXIT button to return to the
previous menu.
Press USB button to exit the USB
mode.
/
/ /
folder
PLAY/PAUSE
REV
STOP
PREV
REPEAT
NEXT
1
2
2
3
3
4
4
5
5
6
6
7
7
1
Note you may play the pictures among selected.
1.Play mode: None/Dissolve/Wipe right/Wipe left/
Wipe up/Wipe down/Box in/Box out
2.Play time: Short/Medium/Long;
3.File name 4.Pause/Play
5. Duration/Rotate 6.Effect
7.Infomation
1.Play or pause;
2.Stop;
3.Repeat;
4.No available;
5.No available;
6.Play previous picture;
7.Play next picture.