Filter
Top Products
Setting Up Your Remote Control
Code Display Mode
1 Press and release SELECT button to desired device.
2 Press and hold OK button, then press SELECT button about 3 seconds till
LED is on. Release 2 keys. LED flashes with the speed of twice per second.
3 Enter [9][8][0] in turn to enter Code Display Mode . LED is off.
4 Press and release [1] once, LED will flash. The times LED flashes is the first digit
of code number.(no flash = 0)
5 Press and release [2] once, LED will flash. The times LED flashes is the second
digit of code number. (no flash = 0)
6 Press and release [3] once, LED will flash. The times LED flashes is the third digit
of code number. (no flash = 0)
7 Code Display process is end and exit the mode automatically.
8 Under Code Display Mode, the remote controller will be no reaction to other buttons
pressed, and will automatically exit the mode if no any key is pressed within 10 seconds.
Operation
36 TFT-LCD TV
SELECT
CH.LIST
FAV.LIST
AUDIO LIST
PIP SWAP
AUDIO SWAP
POSITION
CC
P.MODE
S.MODE
FREEZE
E
N
U
TI
ME
N
PU
T
IN
F
O
E
X
IT
R
A
C
S
A
P
S
L
E
E
P
VOL+
CH+
Q.VIEW
OK
VO
L
-
CH-