Haier L19TC11W TV DVD Combo User Manual


 
Connection Instructions
You can use your LCD-TV as a monitor for your personal computer using a VGA
cable (not supplied).
VGA Input
Connection and use steps:
1.Read the user guide supplied with
your computer and ensure that it has
a VGA connector;
2.Make sure that the power of the LCD
-TVandthePCareoff;
3.ConnectaDtype15-pinVGAinterface
cable ( not supplied ) to the VGA video
interface connector on the PC. Then
connect the other end to the PC video
interface connector on the back of the
LCD-TV.Tighten the screws on the VGA
connectors once they are firmly
connected, connect the audio cable(not
supplied)to the audio input on the back of
your LCD-TV;
4.Turn on the power of the LCD-TV first ,
and then turn on the power of the PC;
5.Press the button to set the video
input mode of the LCD-TV to PC;
6.
SOURCE
Check the image on your TV. There may be noise associated with the resolution,
vertical pattern, contrast or brightness in PC mode. If noise is present, change
the PC mode to another resolution, change the refresh rate to another rate or
adjust the brightness and contrast on the menu until the picture is clear. If the
refresh rate of the PC graphic card cannot be changed,change the PC graphic
card or consult the manufacturer of the PC graphic card.
Frame frequency (Hz)Line frequency (Khz)
VGA
SVGA
XGA
640*480 31.5KHz 60Hz
800*600 37.9KHz 60Hz
1024*768 48.4KHz 60Hz
Mode Resolution
Note:All above listed are subject to VESA Criteria.
YPbPr Input
Connect the DVD video outputs (Y, PB, PR)
totheCOMPONENT(Y,Pb,Pr)INsocketon
the TV and connect the DVD audio outputs
to the AUDIO IN jacks on the TV, as shown
in the figure.
If your DVD player does not have
component video output, use S-Video.
1. Turn on the DVD player, insert a DVD.
2. Use the button on the remote control to select
How to connect
NOTE:
Howtouse
SOURCE
VGAIN