Filter
Top Products
Adjust Menu
Aspect Ratio
Press this key to select the screen display proportion.
Auto Adjust
This is used to reset the default setting parameters.
Clock
This is used for adjusting H Position and V Position as
well as relative parameters in PC modes.
Phase
This is used for adjusting the phase of pixel clock in PC
mode.
Adjust
Vertical and Horizontal position of picture can be
adjusted in this item.
OK
OK
The TV can be used as a display, and you may adjust relevant settings. The operating
method of various menus is the same as that described for TV signal. The following are
operating methods that different from that for TV signal.
When the TV is used as a display, you may set and
adjust its picture effect by the following steps.
Press SOURCE to switch the signal input to PC mode.
1. Press MENU to display the screen main menu, and
then press / to select the Adjust menu as shown in
the right figure.
2. Press to select the option to be adjusted.
3. Press / to adjust it.
/
Precautions:
1. When making H-Size, V-Size, H-Position or V-Position
adjustment, there sometimes may be abnormalities in
case of a large adjustment range, which is not a fault but
for the signal sync out of range, and the picture will
become normal by reverse adjustment.
2. In PC mode, there are only two aspect ratios (4:3, full
screen) available.
3. There will be a display proportion of "Dot By Dot" when
the singal is 1080P 50Hz in the source of YPbPr or HDMI.
This proportion is for Full-HD panel test in factory. Plseae
do not use this proportion, otherwise the display will be
distortionary.
(Only for L42M9/ L46M9/ L55M9/ LB42R3/ LB46R3/
LP55R3 )
menu