Filter
Top Products
CAUTION: Don't let your machine display the same picture for a long time, please set up a screen protection
procedure. If a high contrast picture remains for along time, this picture will bring a 'leave shadow' in screen.
Usually the 'leave shadow' will disappear gradually when you turn off the machine power. However, this trouble
can't be repaired , Which isn't in range of warranty.
Electrical release at turning off.
It is normal.
Noise Signals at turning off.
Remote control distance is
short, lose control.
1.Remove objects, avoiding cover the receive
window of remote control.
2.Change battery.
Computer display faintly.
1.Adjustment is incorrect.
2.Display mode is incorrect.
1.Use auto-adjustment function.
2.Use commend mode.
Computer display image
excursion, not full screen,
over screen.
1.Adjustment is incorrect.
2.Display mode is incorrect.
1.Use auto-adjustment function.
2.Enter to adjust horizontal or
vertical position.
3.Use recommended mode.
"GEOMETRIC"
Symptom
Factor
Solution
Computer no display, and
prompt no signal input, red
indicator LED twinkling.
Signal cable is loose or fall off.
Check signal cable whether or not loose, fall off,
reconnect well again.
Exterior influence, for example
lightning, static electricity and so
on, which are possibly to disturb
the normal operation of this
machine.
Can not operate this
machine.
Press " " button to turn off electrical source,
then press " " button to turn on the TV again
after 1-2 minutes.
1.Receive window of remote
continue was covered by
objects.
2.The battery energy of remote
control is to low.
30
HAIER 19L11A / 22L11A / 23L11 ( )(6M16